> Electrical materials > Switches > Niko switches

Niko switches

Prices are exclusive of VAT.

Filters

Filter on:

? Either show items that are in stock or items that are not in stock.

? A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.

Version of the ballast.

? If the product is unbranded, we do not have a regular supplier for it. Therefore, the product version may slightly vary.

? Connection type of the output.

The way the power can be connected.

? The way the power can be tapped for looping through.

? Depth in millimetres.

? Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.

This may be a fixed voltage or two values with a hyphen.
You can use the product within these limits.

? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.

? Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.

? The minimum power must be connected to the transformer to work properly. If the assets are below the transformer behave abnormally. Known phenomena are electronic transformers are flashing lights, brighter and fainter burning lamps and no output voltage.

A conventional wound transformer must be at least 75% of the maximum power charge. If the load is below this limit, the output voltage too high making the lamps extremely much shorter life. The color of the lamps is usually very white.

? Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!

? Product shape.

? Maximum width in millimetres.

Width

? Maximum width in millimetres.

Show all filters

Show less filters