LED soffit lamps

Prices are exclusive waste disposal fee.

Prices are exclusive of VAT.

Filters

Filter on:

? Either show items that are in stock or items that are not in stock.

? The life span of a party of lamps of which 50% of the lamps will continue to function. Sometimes, incandescent or halogen lamps may become defective more quickly, but in case 50% of the lamps do still reach the lifespan, the lamps are still OK.

? The wider the light beam, the larger the illuminated surface. Brightness decreases as the beam widens, since the light is divided over a larger area.
For creating high contrasts it is therefore recommended to apply smaller light beams. However, contrasts that are too high can be distracting and can cause adjustment problems for the eye, which can be tiring. On the other hand, too little contrast creates a dull and flat impression.

? If the product is unbranded, we do not have a regular supplier for it. Therefore, the product version may slightly vary.

? Light sources can be classified on the basis of their colour rendering properties. The unit for colour rendering is called CRI (Colour Rendering Index, or CRI Ra value). The scale of the Ra is from 50 to 100.
Ra = 90-100 excellent colour rendering properties
Ra = 80-90 good colour rendering properties
Ra = 60-80 moderate colour rendering properties
Ra <60 poor colour rendering properties
Fluorescent and PL lamps with an equal power, the luminous flux of Ra 90-100 tubes is typically 20% lower.

? Diameter in millimetres, measured at the widest point.

? Glass colour.

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

? Cap, lamp holder or lamp base type.

? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.

? The amount of light transmitted by the light source per second. The unit of luminous flux is the lumen (lm).

? The life span of a lamp may be limited by the number of switch cycles, which is the number of times a lamp can be switched on and off before it becomes defective.

? This may be either a fixed voltage or two values, in which case the product can be used within these limits.

? The power that the bulb consumes. This does not include the loss of any ballast or transformer.

? Replacement bulb power specified by the manufacturer. A CFL and LED display average 5x as much light compared to a standard bulb. To the CFL or LED power available divide the bulb power by 5.

Luminous flux