> Lighting components > Dimmers, Dali and 1-10V controllers > Dimmers various types

Dimmers various types

Prices are exclusive of VAT.

Dimmers various types

Filters

Filter by:

? Either show items that are in stock or items that are not in stock.

? A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.

? If the product is unbranded, we do not have a regular supplier for it. Therefore, the product version may slightly vary.

? Most common colour in the product. When it comprises multiple colours, these are included in the description, separated by a slash (/).

? Connection type of the output.

?

The way the power can be connected.

? The way the power can be tapped for looping through.

? Depth in millimetres.

? Diameter in millimetres, measured at the widest point.

? Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.

? Maximum height in millimetres.

?

This may be a fixed voltage or two values with a hyphen.
You can use the product within these limits.

?

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.

? Material from which the major part of the product is made. When it comprises multiple materials, these are included in the description, separated by a slash (/).

? Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.

? The minimum power must be connected to the transformer to work properly. If the assets are below the transformer behave abnormally. Known phenomena are electronic transformers are flashing lights, brighter and fainter burning lamps and no output voltage.

A conventional wound transformer must be at least 75% of the maximum power charge. If the load is below this limit, the output voltage too high making the lamps extremely much shorter life. The color of the lamps is usually very white.

? Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!

? Product shape.

? This may be either a fixed voltage or two values, in which case the product can be used within these limits.

? Maximum width in millimetres.

Height

>

>

? Maximum height in millimetres.

Width

>

>

? Maximum width in millimetres.

Show all filters

Show less filters

26 products 1 2

Arditi 038031 inbouw dimmerprint 3A 12V DC 36W of 24V DC 72W met touchdim functie

29102158 :: show details

Arditi 038031 inbouw dimmerprint 3A 12V DC 36W of 24V DC 72W met touchdim functie

log in to order

Expected 03-08-2026

Arditi 038306 100-240V inbouw dimmerunit met touchdim functie zwart

29103059 :: show details

Arditi 038306 100-240V inbouw dimmerunit voor LED lampen 4-25W, spaarlampen 11-25W, gloei- en halogeenlampen 230V 4-250W, gloei- en halogeenlampen 120V 4-200W met touchdim functie zwart Geschikt voor maximaal 4 LED- of spaarlampen

log in to order

Expected 23-07-2026

Busch&Jaeger dimmer 2-100W LED 6512-0-0339 opbouw voor DIN rail montage

72300121 :: show details

Busch&Jaeger dimmer 2-100W LED 6512-0-0339 opbouw voor DIN rail montage

log in to order

Expected 18-07-2026

SLV 1006452 fase-afsnij dimmer met DALI besturing

29106144 :: show details

SLV 1006452 fase-afsnij dimmer met DALI besturing

log in to order

Expected 17-07-2026

Osram Halotronic HTi DALI 315 DIM 20-315W elektronische dimmer module DALI

29100443 :: show details

Osram Halotronic HTi DALI 315 DIM 20-315W elektronische dimmer module DALI

log in to order

Only 3 items in stock

Last stock

Tronix 214-177 DALI dimmer 200W inbouwmodel

29100270 :: show details

Tronix 214-177 DALI dimmer 200W inbouwmodel 200W LED, 200W dimbare LED drivers, 400W gloeilamp of 230V halogeenlamp en 200W electronische halogeentransformatoren

replaced by: Article 29102655

log in to order

Only 1 items in stock

Last stock

Prices ex. shipping & handling

You have viewed 26 of 26 items

26 products 1 2

© 2026 First Light B.V.