Nederlands Deutsch Francais English
0
   Cart

LED driver for 250mA LED



Prices are exclusive of VAT.
LED driver for 250mA LED
Filters
Filter by:
Either show items that are in stock or items that are not in stock.
? The life span of a party of lamps of which 50% of the lamps will continue to function. Sometimes, incandescent or halogen lamps may become defective more quickly, but in case 50% of the lamps do still reach the lifespan, the lamps are still OK.
? A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
?

Version of the ballast.

? The wider the light beam, the larger the illuminated surface. Brightness decreases as the beam widens, since the light is divided over a larger area.
For creating high contrasts it is therefore recommended to apply smaller light beams. However, contrasts that are too high can be distracting and can cause adjustment problems for the eye, which can be tiring. On the other hand, too little contrast creates a dull and flat impression.
? If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
? Most common colour in the product.
? Light colour is often represented with a 3 digit number. The first digit indicates the CRI (Colour Rendering Index) or CRI Ra value:
5 = 50-59
6 = 60-69
7 = 70-79
8 = 80-89
9 = 90-99
The last 2 digits are for colour temperature.
The higher the colour temperature, the cooler the impression of light.
Warm white creates a cosy, welcoming atmosphere. Neutral cool-white creates a more businesslike atmosphere.
Low lighting levels in interior must be obtained with warm-white light. If a very high level of light is needed, this must be achieved with neutral or cool white light.
2700K extra warm white
3000K warm white
3500K neutral white
4000K cool white
5000-5500K daylight
6000K cool daylight
? Light sources can be classified on the basis of their colour rendering properties. The unit for colour rendering is called CRI (Colour Rendering Index, or CRI Ra value). The scale of the Ra is from 50 to 100.
Ra = 90-100 excellent colour rendering properties
Ra = 80-90 good colour rendering properties
Ra = 60-80 moderate colour rendering properties
Ra <60 poor colour rendering properties
Fluorescent and PL lamps with an equal power, the luminous flux of Ra 90-100 tubes is typically 20% lower.
?

Colour temperature is expressed in kelvin (K). The higher the colour temperature, the cooler the impression of the light:

2700K: extra warm white
3000K: warm white
3500K: neutral white
4000K: cool white
5000-5500K: daylight
6000K: cool daylight

Extra warm white creates a warm, inviting atmosphere (e.g. hotel, living room, and catering). Warm white can be used for a pleasant atmosphere (e.g. retail and office). Neutral cool white creates a more businesslike atmosphere, this color gives a sterile atmosphere.
Low lighting levels are obtained in interior with warm white light. If a very high level of light is needed, neutral or cool white light is a good choice.

? Connection type of the output.




?

The way the power can be connected.

? The way the power can be tapped for looping through.
? Diameter in millimetres, measured at the widest point.
?

Dim to warm is a dimming technique that adjusts colour temperature as the light is dimmed: it shifts from warm white to extra warm white when fully dimmed. This technique has various names, such as Dimtone or Glowdim.

? Dim type: AM, PWM or hybrid.
? Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.
? Glass colour.
? Maximum height in millimetres.
?
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
?

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

? Cap, lamp holder or lamp base type.
? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
? The amount of light transmitted by the light source per second. The unit of luminous flux is the lumen (lm).
? Material of which the major part of the product is made.
? Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.
? The minimum power must be connected to the transformer to work properly. If the assets are below the transformer behave abnormally. Known phenomena are electronic transformers are flashing lights, brighter and fainter burning lamps and no output voltage.

A conventional wound transformer must be at least 75% of the maximum power charge. If the load is below this limit, the output voltage too high making the lamps extremely much shorter life. The color of the lamps is usually very white.
? The life span of a lamp may be limited by the number of switch cycles, which is the number of times a lamp can be switched on and off before it becomes defective.
? Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!
? The output voltage is indicated here. Voltage-controlled LEDs must always be connected in parallel.
? Product shape.
? This may be either a fixed voltage or two values​​, in which case the product can be used within these limits.
? The power that the bulb consumes. This does not include the loss of any ballast or transformer.
? Maximum width in millimetres.
Height
>
>
? Maximum height in millimetres.
Luminous flux
>
>
? The amount of light transmitted by the light source per second. The unit of luminous flux is the lumen (lm).
Width
>
>
? Maximum width in millimetres.


67 products     1 2 3 4


EUCHIPS PUP10T-1HMC-350 LEDdriver 120 t/m 350mA dimbaar met bedrading

 

50 items in stock
SPL Flex filament LED double tube lamp 4,9W E27 220V-240V 922 2200K goud dimbaar

 

Expected 29-06-2026
ELT 9907182 DLCM 25/250...600-2E-C2-M4D LEDdriver 250 t/m 600mA 25W Dali, Dali-2, 0-10V, 1-10V, 10V PWM dimbaar opbouw met trekontlasting instelbaar d.m.v. dipswitches 250mA 3,5-10,5W, 300mA 4,2-12,6W, 350mA 4,9-14,7W, 400mA 5,6-16,8W, 450mA 6,3-18,9W, 500mA 7-21W, 550mA 7,7-23,1W, 600mA 8,4-25,2W

 

70 items in stock
ELT 9907185 DLCM 14/120...350-3B-C2-M2D LEDdriver 120 t/m 350mA Dali, Dali-2 dimbaar opbouw met trekontlasting instelbaar d.m.v. dipswitches 120mA 1,7-4,8W, 160mA 2,2-6,4W, 180mA 2,5-7,2W, 220mA 3,7-8,8W, 250mA 3,5-10W, 280mA 3,9-11,2W, 350mA 4,9-14W

 

43 items in stock
HEP G5LT10W250LR-Z 250mA 7,5-10,5W LEDdriver dimbaar opbouw met trekontlasting

 

58 items in stock
HEP LWTC20W500CALR 3f railadaptor met ingebouwde LED driver 250-500mA 20W dimbaar wit

 

Expected 01-07-2026
HEP LWTC20W500CALR 3f railadaptor met ingebouwde LED driver 250-500mA 20W dimbaar zwart

 

11 items in stock
Interlight IL-D14DALI2L LED driver 120-350mA Dali dimbaar instelbaar d.m.v. dipswitches 120mA 1,7-4,8W, 160mA 2,3-6,4W, 180mA 2,5-7,2W, 220mA 3,1-8,8W, 250mA 3,5-10W, 280mA 3,9-11,2W, 350mA 4,9-14W

 

Expected 28-06-2026
Osram Element EM Fit 40/220-240/350 D CS L LED driver 200mA 11-42W, 250mA 13,8-42W, 300mA 16,5-42W en 350mA 19,3-42W niet dimbaar uitgangsstroom instelbaar met dipswitch

 

Expected 30-06-2026
Osram OT FIT D L 60/220…240/350 CS L multifunctionele LED driver inbouwmodel niet dimbaar uitgangsstroom instelbaar met dipswitch 100mA 9-17,5W, 150mA 13,5-26,2W, 200mA 20-35W, 250mA 22,5-43,7W, 300mA 27-52,5W en 350mA 31,5-60W

 

Expected 30-06-2026
TCI 122201 Universale 20 instelbare LED Driver opbouw

 

40 items in stock
TCI 122201BI Universale 20 instelbare LED driver inbouw

 

Expected 08-07-2026
TCI 127102 Puma MD LED driver 250-900mA 20W dimbaar opbouw met trekontlasting AM

 

48 items in stock
TCI 127444 Mini MD LP LED driver 250mA 8-12,5W dimbaar

 

25 items in stock
TCI 127480N Professionale 34 multifunctionele LED driver opbouwmodel met trekontlasting niet dimbaar

 

9 items in stock
TCI 127482 Professionale 34 BI multifunctionele LED driver inbouwmodel niet dimbaar

 

13 items in stock
TCI 127699 LEDdriver 250mA 0,5-10W DCC HPFU niet dimbaar opbouw met trekontlasting

 

5 items in stock
TCI 141133 BULL HPFU LED driver 250mA 0,5-9W

 

5 items in stock
TCI 152014/250 IPR2 12/250 LED driver 1-12W 250mA IP68 niet dimbaar met kabels 400mm voor in- en uitgang

 

5 items expected 25-06-2026
Tronix 214-184 LED driver instelbaar 250-1000mA 30W RF dimbaar

 

Expected 27-06-2026
You have viewed 20 of 67 items

67 products     1 2 3 4