Nederlands Deutsch Francais English
0
   Cart

LED DMX controller



Prices are exclusive of VAT.
LED DMX controller
Filters
Filter on:
Either show items that are in stock or items that are not in stock.
? A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
?

Version of the ballast.

? If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
? Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.
? Not every dimmable ballast or light source can dim to 0% level, here is the dimming range.
? Maximum height in millimetres.
?
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
? Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.
? Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!
? The output voltage is indicated here. Voltage-controlled LEDs must always be connected in parallel.
? This may be either a fixed voltage or two values​​, in which case the product can be used within these limits.
? Maximum width in millimetres.
Height
>
>
? Maximum height in millimetres.
Width
>
>
? Maximum width in millimetres.


15 products     1  


ELT 9955920 DMX-MULTI-C02 4 kanalen 5A RGBW 12V 240W 24V 480W 36V 720W

 

Expected 20-05-2026
Artecta A9915011 LED DMX controller 12V 180W 24V 288W

 

Expected 14-05-2026
DMX Kabel 110 Ohm 2x0,22mm per m

 

Expected 14-05-2026
QLT DMX200 DMX-DALI naar PWM interface om met een voeding van 12V of 24V DC een uitgangsspanning van 12V of 24V DC maximaal 3x2A te krijgen wat via DMX of DALI gedimt kan worden. Er moet nog een externe voeding van 12V of 24V DC op aangesloten worden.

 

Expected 14-05-2026
QLT LED DMX interface voor KRGBBOX om de LED driver geschikt te maken voor DMX aansturing

 

Only 1 items in stock

Last stock
Showtec DMX kabel XLR/M 3p XLR/F 3p 10m FL0910

 

Expected 14-05-2026
Showtec DMX kabel XLR/M 3p XLR/F 3p 15m FL0910

 

Expected 14-05-2026
Showtec DMX kabel XLR/M 3p XLR/F 3p 1m50

 

4 items in stock
Showtec DMX kabel XLR/M 3p XLR/F 3p 20m

 

Expected 14-05-2026
Showtec DMX kabel XLR/M 3p XLR/F 3p 3m FL093

 

2 items in stock
Tronix 214-113 LED DMX controller 12V 180W 24V 288W UTP in en uit

 

Only 1 items in stock

Last stock
Tronix 214-113 LED DMX controller 12V 216W 24V 432W

 

Expected 13-05-2026
eldoLED 50SA-M4Z0X POWERdrive LEDdriver 50W 4 kanalen 150-1400mA DMX opbouw met trekontlasting programmeerbaar met FluxTOOL software Deep dimming, Dim to dark van 0,1-100%

 

Expected 15-05-2026
LTECH LM-150-24-G4K3 LEDvoeding 24V 150W RGB+W 4 kanalen Dali, Dali 2, DMX en push to dim

 

Expected 24-05-2026
QLT RGBBOX 424EB LED voeding 24V 100W RGB+W in te stellen voor 3 of 4 kanalen Dali, DMX en push to dim Maximaal 10 boxen door te koppelen

 

Expected 14-05-2026
You've viewed 15 of 15 items

15 products     1