Nederlands Deutsch Francais English
0
   Cart

QLT DPL110E LED driver 350mA voor 1 tot 9 LED's 350mA serieschakeling 10W

Article ID:
29900631



New stock expected on:  
25-05-2026 After placing the order




Properties
Manufacturer's article number DPL110E Manufacturer's part number.
Ballast LED Converter A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
Brand QLT If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
Height 22mm Maximum height in millimetres.
Input voltage 198V-264V
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
IP protection degree IP20

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

Length 117mm Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
Ouput current 350mA Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!
Pieces per outer carton 1 Number of pieces per outer carton. To order full boxes of the item, please add it to your shopping basket in multiples of this amount.
Shape Rectangular Product shape.
Width 50mm Maximum width in millimetres.
EAN code 8720584137610 EAN code is the barcode of an article which is used worldwide as article code. The EAN code extra is the code from the extra packing.
EAN code (extra) 3.10.0003 EAN code is the barcode of an article which is used worldwide as article code. The EAN code extra is the code from the extra packing.
QLT DPL110E LED driver 350mA voor 1 tot 9 LED's 350mA serieschakeling 10W
Downloads Your corrections
Remarks
Full name
Phone
Email address