Nederlands Deutsch Francais English
0
   Cart

eldoLED ECOdrive 32P-D1Z0D LEDdriver 32W 150-1050mA Dali 2 48V print voor inbouw programmeerbaar met FluxTOOL software compatible met Stucchi MULTISYSTEM track adapter

Article ID:
29100695



New stock expected on:  
10-07-2026 After placing the order




Properties
Manufacturer's article number 32P-D1Z0D Manufacturer's part number.
Ballast LED Converter A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
Ballast version Built-in ballast without strain relief

Version of the ballast.

Brand EldoLED If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
Dimmable Dali, Pushbutton, Dali-2 Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.
Dimming range 1-100% Not every dimmable ballast or light source can dim to 0% level, here is the dimming range.
Height 12mm Maximum height in millimetres.
Input voltage 48V DC (direct current)
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
Length 136,4mm Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
Ouput current 150mA-1050mA Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!
Pieces per outer carton 50 Number of pieces per outer carton. To order full boxes of the item, please add it to your shopping basket in multiples of this amount.
Width 14,5mm Maximum width in millimetres.
eldoLED ECOdrive 32P-D1Z0D LEDdriver 32W 150-1050mA Dali 2 48V print voor inbouw
programmeerbaar met FluxTOOL software
compatible met Stucchi MULTISYSTEM track adapter
Downloads Your corrections
Remarks
Full name
Phone
Email address