Nederlands Deutsch Francais English
0
   Cart

LED driver multifunctional


LED junction boxes can be found here.

Prices are exclusive of VAT.
LED driver multifunctional
Filters
Filter on:
Either show items that are in stock or items that are not in stock.
? A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
?

Version of the ballast.

? If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
? Connecting cable length in metres.
? Most common colour in the product.
? Articles classified by component type.
? Connection type of the output.




?

The way the power can be connected.

? The way the power can be tapped for looping through.
? Diameter in millimetres, measured at the widest point.
? Dim type: AM, PWM or hybrid.
? Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.
? Not every dimmable ballast or light source can dim to 0% level, here is the dimming range.
? Maximum height in millimetres.
?
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
?

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

? Luminaire including or excluding lamp(s).
? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
? Material of which the major part of the product is made.
? Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.
? The minimum power must be connected to the transformer to work properly. If the assets are below the transformer behave abnormally. Known phenomena are electronic transformers are flashing lights, brighter and fainter burning lamps and no output voltage.

A conventional wound transformer must be at least 75% of the maximum power charge. If the load is below this limit, the output voltage too high making the lamps extremely much shorter life. The color of the lamps is usually very white.
? Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!
? The output voltage is indicated here. Voltage-controlled LEDs must always be connected in parallel.
? Outside Dimension is the largest size, often of the lamp head.
? Product shape.
? This may be either a fixed voltage or two values​​, in which case the product can be used within these limits.
? Maximum width in millimetres.
Height
>
>
? Maximum height in millimetres.
Width
>
>
? Maximum width in millimetres.


206 products   2 3 4 5 6 7 8


TCI 122213 MP80/700 slim LEDdriver 325-700mA 80W

 

2 items in stock
TCI 122214I MP80/500 slim LEDdriver 350-500mA 80W niet dimbaar

 

9 items in stock
TCI 122219 Smart 50 BI multifunctionele LED driver inbouwmodel niet dimbaar

 

10 items in stock
TCI 122220 Smart 50 multifunctionele LED driver opbouwmodel met trekontlasting niet dimbaar

 

7 items in stock
TCI 122260 DC Jolly MD32 trail/leading dimbaar met L of C dimmer + push and dim multifunctionele LED driver Let op jumper JP1 instelling voor keuze dimwijze

 

35 items in stock
TCI 122262 DC Jolly MD LC 24 trail/leading dimbaar met L of C dimmer + push and dim multifunctionele LED driver Let op jumper JP1 instelling voor keuze dimwijze

 

10 items in stock
TCI 123312 Maxi Jolly HC 60 push and dim en 1-10V dimbaar multifunctionele LED driver

 

Expected 09-05-2026
TCI 123314 Maxi Jolly HC/2 Dali 60 Dali dimbaar, push and dim en 1-10V multifunctionele LED driver

 

14 items in stock
TCI 123406 Mini Jolly PLV multifunctionele LED driver Push en dim functie laagspanning met aparte aansluiting, niet met 230V

 

Expected 16-05-2026
TCI 123417 Maxi Jolly HC Dali BI 60 Dali dimbaar, push and dim en 1-10V multifunctionele LED driver inbouw

 

3 items in stock
TCI 123419 Maxi Jolly US PLV push and dim laagspanning multifunctionele LED driver Push en dim functie laagspanning met aparte aansluiting, niet met 230V

 

Expected 05-05-2026
TCI 123680 DC Jolly Slim 1-10V push and dim multifunctionele LED driver

 

15 items in stock
TCI 125400 Mini Jolly 20 1-10V push and dim multifunctionele LED driver AM/PWM

 

75 items in stock
TCI 125403 DC Mini Jolly Dali 20 multifunctionele LED driver

 

187 items in stock
TCI 125403BI DC Mini Jolly Dali 20 multifunctionele LED driver inbouwmodel

 

51 items in stock
TCI 125404 Mini Jolly 20 BI 1-10V push and dim multifunctionele LED driver inbouwmodel AM/PWM dmv dipswitch intern instelbaar voor verschillende spanningen en stromen. LED stroomsturing 250mA 5-13W, 300mA 6-15W, 350mA 5,3-18W, 400mA 6-20W, 450mA 2,3-20W, 500mA 2,5-20W, 550mA 1,7-20W, 600mA 1,8-20W, 650mA 2-20W, 700mA 2,1-20W, 750mA 2,3-20W, 800mA 2,4-20W, 850mA 2,6-20W en 900mA 2,7-20W LED spanningsturing 12V DC 11W, 24V DC 20W Voor 230V netspanning gelden deze waarden, zie de PDF manual bij gebruik op 11

 

73 items in stock
TCI 125424 DC Jolly Dali 32 multifunctionele LED driver opbouw met trekontlasting AM/PWM

 

85 items in stock
TCI 125425 DC Jolly US PLV push and dim laagspanning multifunctionele LED driver Push en dim functie laagspanning met aparte aansluiting, niet met 230V

 

32 items in stock
TCI 125450 DC Jolly US BI 1-10V push and dim multifunctionele LED driver inbouw


replaced by: Article 29103037
 

Only 15 items in stock

Last stock
TCI 125458 DC Jolly Dali 32 BI multifunctionele LEDdriver inbouwmodel AM/PWM

 

15 items in stock
You've viewed 100 of 206 items

206 products   2 3 4 5 6 7 8