Nederlands Deutsch Francais English
0
   Cart

LED power supply for 12V DC LED



Prices are exclusive of VAT.
LED power supply for 12V DC LED
Filters
Filter on:
Either show items that are in stock or items that are not in stock.
? A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
?

Version of the ballast.

? If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
? Most common colour in the product.
? Connection type of the output.




?

The way the power can be connected.

? The way the power can be tapped for looping through.
? Diameter in millimetres, measured at the widest point.
? Dim type: AM, PWM or hybrid.
? Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.
? Maximum height in millimetres.
?
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
?

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

? Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
? Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.
? The minimum power must be connected to the transformer to work properly. If the assets are below the transformer behave abnormally. Known phenomena are electronic transformers are flashing lights, brighter and fainter burning lamps and no output voltage.

A conventional wound transformer must be at least 75% of the maximum power charge. If the load is below this limit, the output voltage too high making the lamps extremely much shorter life. The color of the lamps is usually very white.
? Each type of LED requires a different driver. Current-controlled LEDs of 350, 700, 1050 and 1400mA need to be connected in series. This can be easily done with an LED distributor. Unused outputs are shorted with a wire . First connect the wires, then you can put power on! Never disconnect wires under power!
? The output voltage is indicated here. Voltage-controlled LEDs must always be connected in parallel.
? Outside Dimension is the largest size, often of the lamp head.
? Product shape.
? Maximum width in millimetres.
Height
>
>
? Maximum height in millimetres.
Width
>
>
? Maximum width in millimetres.


63 products     1 2 3 4


ELT 9907133 LV 200/12-T-IP67 200-240V 75...200W 12V

 

Expected 27-04-2026
TCI 122420 DC Jolly 1-10V push and dim multifunctionele LED driver

 

Only 14 items in stock

Last stock
Arditi 035780 LED voeding 12V DC 17W zwart

 

Expected 25-04-2026
Arditi 800514 LED voeding 12V DC 132W

 

Expected 24-04-2026
ELT 9907111 LV 180/12-C2 200-240V-IP20 LED voeding 12V DC 100W-180W 200-240V

 

2 items in stock
ELT 9907113 LV 260/12-C2 200-240V-IP20 LED voeding 12V DC 150W-260W 200-240V

 

Expected 27-04-2026
Relco PTDCD/100 LED voeding 12V 60W 24V 100W DC omschakelbaar dimbaar met externe drukknop, potmeter of 1-10V

 

Expected 20-05-2026
ELT 9907103 LV 15/12-C2 LED voeding 12V DC 15W

 

13 items in stock
ELT 9907104 LV 20/12-C2 LED voeding 12V DC 20W

 

14 items in stock
ELT 9907105 LV 30/12-C2 LED voeding 12V DC 30W

 

38 items in stock
ELT 9907107 LV 50/12-C2 LED voeding 12V DC 50W

 

4 items in stock
ELT 9907108 LV 75/12-C2 LED voeding 12V DC 75W

 

16 items in stock
ELT 9907109 LV 100/12-C2 LED voeding 12V DC 40-100W

 

6 items in stock
ELT 9907110 LV 130/12-C2 LED voeding 12V DC 70-130W

 

5 items in stock
TCI 122200 MP32 K2 multifunctionele LED driver niet dimbaar opbouw met trekontlasting

 

Expected 04-05-2026
TCI 122260 DC Jolly MD32 trail/leading dimbaar met L of C dimmer + push and dim multifunctionele LED driver Let op jumper JP1 instelling voor keuze dimwijze

 

35 items in stock
TCI 122262 DC Jolly MD LC 24 trail/leading dimbaar met L of C dimmer + push and dim multifunctionele LED driver Let op jumper JP1 instelling voor keuze dimwijze

 

10 items in stock
TCI 123406 Mini Jolly PLV multifunctionele LED driver Push en dim functie laagspanning met aparte aansluiting, niet met 230V

 

Expected 11-05-2026
TCI 125400 Mini Jolly 20 1-10V push and dim multifunctionele LED driver AM/PWM

 

75 items in stock
TCI 125404 Mini Jolly 20 BI 1-10V push and dim multifunctionele LED driver inbouwmodel AM/PWM dmv dipswitch intern instelbaar voor verschillende spanningen en stromen. LED stroomsturing 250mA 5-13W, 300mA 6-15W, 350mA 5,3-18W, 400mA 6-20W, 450mA 2,3-20W, 500mA 2,5-20W, 550mA 1,7-20W, 600mA 1,8-20W, 650mA 2-20W, 700mA 2,1-20W, 750mA 2,3-20W, 800mA 2,4-20W, 850mA 2,6-20W en 900mA 2,7-20W LED spanningsturing 12V DC 11W, 24V DC 20W Voor 230V netspanning gelden deze waarden, zie de PDF manual bij gebruik op 11

 

73 items in stock
You've viewed 20 of 63 items

63 products     1 2 3 4