Nederlands Deutsch Francais English
0
   Cart

SPL 605100502 LED voeding 12V DC 40W dimbaar

Article ID:
29101786



3 items currently in stock
New stock expected on:  
18-04-2026 After placing the order




Properties
Manufacturer's article number 605100502 Manufacturer's part number.
Ballast LED Converter A conventional ballast has a wound coil. It is somewhat cheaper to buy, but more expensive to run because more power is converted into heat. An electronic ballast not only has a lower power consumption, but it also has the advantage of longer lamp life.
Ballast version Surface-mounted with strain relief

Version of the ballast.

Brand SPL If the product is unbranded, we do not have a regular supplier for itTherefore, the product version may slightly vary.
Connection output 1 x springclamp Connection type of the output.




Connection power input 1 x springclamp

The way the power can be connected.

Connection power output No The way the power can be tapped for looping through.
Dimmable Yes, L dimmer (Conventional transformer), C dimmer (Tronic electronic transformer) Some lamps and ballasts are dimmable. There are different types of dimmers and different ways to dim a ballast or transformer. In case of insufficient knowledge, please check with our sales department.
Height 31mm Maximum height in millimetres.
Input voltage 200V-240V
This may be a fixed voltage or two values ​​with a hyphen.
You can use the product within these limits.
IP protection degree IP20

The IP (Ingress Protection) code indicates the degree of protection against ingress of moisture and solid objects. The code consists of two firures.
The first figure indicates the protection against objects and dust:
IP 0x - not protected
IP 1x - protected against objects with a diameter above 50 mm
IP 2x - protected from objects with a diameter greater than 12 mm (touch safe)
IP 3x - protected from objects with a diameter greater than 2.5 mm
IP 4x - protected against objects with a diameter greater than 1 mm
IP 5x - protected against dust ( dust )
IP 6x - dustproof

The second figure indicats the protection against water:
IP x0 - unprotected (plain)
IP x1 - Protected against dripping water (drip)
IP x2 - Protected against dripping water when tilted to 15 degrees
IP x3 - protected against spraying water (rain tight)
IP x4 - protected against splashing water (splash proof)
IP x5 - protected against water jets (splashproof)
IP x6 - protected from rainstorms
IP x7 - protected against accidental immersion (30 minutes to 1 meter deep) (waterproof)
IP x8 - protected from stay under water (pressure proof)

Length 137mm Product length in millimetres. For fluorescent tubes, this excludes the metal pins on the end unless otherwise stated.
Maximum wattage 40W Maximum amount of power, expressed in watts, that can be connected to the transformer in order to work properly. If the assets exceed this maximum amount, the transformer may behave abnormally: known phenomena in electronic transformers are the lights switching on and off, and no output voltage.
Output voltage 12V DC (direct current) The output voltage is indicated here. Voltage-controlled LEDs must always be connected in parallel.
Pieces per outer carton 1 Number of pieces per outer carton. To order full boxes of the item, please add it to your shopping basket in multiples of this amount.
Width 82mm Maximum width in millimetres.
EAN code 8718739076341 EAN code is the barcode of an article which is used worldwide as article code. The EAN code extra is the code from the extra packing.
EAN code (extra) EAN code is the barcode of an article which is used worldwide as article code. The EAN code extra is the code from the extra packing.
SPL 605100502 LED voeding 12V DC 40W dimbaar
Downloads Your corrections
Remarks
Full name
Phone
Email address